CKP Question

tendle · Post by **tendle** » Sat Sep 13, 2014 8:38 am

So i recieved a p0335 code so i replaced the ckp sensor. went for a short drive and when i started to accelerate with a little quickness the rpms jumped all over the place. and now i am receiving a p0339 code. does anyone know what the pin layout is for the plug on that sensor and what proper voltage readings would be for it. or what else is common to cause this issue

Thanks

Post by **occasional demons** » Sat Sep 13, 2014 11:33 am

The connector might be bad, or the wiring to it. Check the harness anywhere it is in contact with anything for chafing.

tendle · Post by **tendle** » Mon Sep 15, 2014 6:25 pm

Thanks i will look into that.

tendle · Post by **tendle** » Sat Sep 20, 2014 4:01 pm

Od should the ckp signal have 5v on it from ecu to the connector. Did a continuity test nothing but proper wires touching

Post by **occasional demons** » Sat Sep 20, 2014 5:49 pm

Should be 5 volts across the orange and black/light blue wires.

tendle · Post by **tendle** » Sun Sep 21, 2014 9:01 am

Well found oil inside the connector, and took the sensor back and got another, and what do you know it has been fixed!!