Alright. I have an MS2 with the 3.0 board in it. I bought it off the for sale section of this forum.
The MS was on a turbo car before mine. Sad thing is, I don't have a turbo car. Every time I get power to the MS to retune it, Tunerstudio doesn't want to be compatible with the firmware.
So, I try to update and reflash the MS. This would be all fine and dandy, but my car has to be on so the MS gets power, and that means running my car with a turbo tune. Not good.
Any suggestions? I got so close to reflashing the MS but my car died, and I don't want to run that turbo tune and blow up my engine (though that is a good excuse for an SRT swap). Please help!
Phil
MegaAnnoying
- sidepipe87
- 2009 Silver Contributor
- Posts: 9516
- Joined: Fri May 30, 2008 5:35 pm
- Location: Pittsburgh, PA
- Contact:
Maybe try talking to Erick Steinmaier about it. He knows his MS shit. esteinmaier is his username here.
PM me for your 00+ PCM SKIM/VIN flashing needs. Neon PCMs Plus
-
- 2GN Member
- Posts: 1019
- Joined: Sun Feb 19, 2006 7:29 pm
- Location: Indianapolis, IN
- Contact:
Re: MegaAnnoying
pbl3 wrote: MegaAnnoying
Yes.... Erik Steinmaier is 'the' MS guru on this board.... Or any Neon forum, for that matter.
- Nick
-1998 2-dr SOHC MTX= 57mm TB; Maddog STS
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm
Official "I'm Going to Drive My Neon till it Dies" Club #000009
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm
Official "I'm Going to Drive My Neon till it Dies" Club #000009