How-To: Affordable exhaust options....
- neonjake27
- 2GN Member
- Posts: 92
- Joined: Thu Mar 18, 2010 8:31 am
- Location: Wadstucky,ohio
- sidepipe87
- 2009 Silver Contributor
- Posts: 9516
- Joined: Fri May 30, 2008 5:35 pm
- Location: Pittsburgh, PA
- Contact:
did that with two and it was still ungodly loud and the drone was making me deaf.. I just had a real DynoMax Super Turbo muffler welded in the rear. It' super quiet now.mikeb818 wrote:hmmm.....just get the 1gn piping with a moroso exhaust. have them put it in the middle. side exit exhaust maybe?? my srt-4 catback is too loud
WARNING TO ALL: Dynomax part 52148 that goes from the intermediate pipe to the muffler is DISCONTINUED with no superceding part number so have fun making a piece to fit. It sucks...
As far as the sway and 2.5" piping... not even close to being a problem. I have a huge Hotchkis bar and there is still plenty of room.
PM me for your 00+ PCM SKIM/VIN flashing needs. Neon PCMs Plus
occasional demons wrote:It cleared mine with no trouble.
sidepipe87 wrote: WARNING TO ALL: Dynomax part 52148 that goes from the intermediate pipe to the muffler is DISCONTINUED with no superceding part number so have fun making a piece to fit. It sucks...
As far as the sway and 2.5" piping... not even close to being a problem. I have a huge Hotchkis bar and there is still plenty of room.
Great to know..... THANKS for the updated info, Everyone !!
- Nick
-1998 2-dr SOHC MTX= 57mm TB; Maddog STS
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm
Official "I'm Going to Drive My Neon till it Dies" Club #000009
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm
Official "I'm Going to Drive My Neon till it Dies" Club #000009
- stairmaster3001
- 2GN Member
- Posts: 524
- Joined: Wed Oct 13, 2010 11:17 am
- Location: mooresville
- sidepipe87
- 2009 Silver Contributor
- Posts: 9516
- Joined: Fri May 30, 2008 5:35 pm
- Location: Pittsburgh, PA
- Contact: