Search found 468 matches
- Mon Mar 11, 2019 7:31 pm
- Forum: Engine
- Topic: Crankshaft tone wheel, reoccurring p0339
- Replies: 2
- Views: 3085
Re: Crankshaft tone wheel, reoccurring p0339
BBR I meant the torx that hold the tone wheel onto the crank. I just rechecked them to make sure they were tight. Wasn't sure of the torque needed so just went over them at 25 ft/lbs. They weren't loose at all so I bought new cam/crank sensors by NTK from rockauto and it fixed that code and the misf...
- Thu Jan 31, 2019 7:36 pm
- Forum: Engine
- Topic: Crankshaft tone wheel, reoccurring p0339
- Replies: 2
- Views: 3085
Crankshaft tone wheel, reoccurring p0339
04 R/T engine in 03 SXT. Has been running pretty stupidly for the last 3months. It all started after I had my CKP sensor go out and stalled during rush hr traffic. I cleaned the connector because it was covered in oil and it drove 2miles before stalling again due to me forgetting to install the inta...
- Sat Feb 07, 2015 11:25 pm
- Forum: General 2nd Gen Discussion
- Topic: Gas Mileage
- Replies: 75
- Views: 24417
Still Only Getting 200 per tank! That's 100 Miles LESS than most of yalls replies!! Everything Is Pretty Much New In This Car, I Just Dont Get It I'm really starting to think its just because the car is only driven a total of 20 minutes/16-18 Miles round trip a day I think that's your only problem ...
- Sun Jan 25, 2015 3:07 pm
- Forum: Suspension, Steering & Brakes
- Topic: Neon Girl Needs Your Help!
- Replies: 14
- Views: 7408
- Sun Jan 11, 2015 6:50 pm
- Forum: Picture Post
- Topic: We'll after 1 year I'm here again..
- Replies: 21
- Views: 12162
- Mon Dec 01, 2014 1:09 pm
- Forum: Tuning / MegaSquirt
- Topic: MegaAnnoying
- Replies: 4
- Views: 8719
- Mon Dec 01, 2014 12:49 pm
- Forum: General 2nd Gen Discussion
- Topic: Greenhouse big crash at Pacific Forest Rally
- Replies: 18
- Views: 5834
Man, something about watching the car at the end of that video come tearing around a corner with the back smashed like that just looked so wrong and bad-ass at the same time. I'm glad that you guys are ok! Hopefully you can get that rear clip on there in good time. :rockon: Theres just something am...
- Mon Dec 01, 2014 12:42 pm
- Forum: Naturally Aspirated
- Topic: 2.0 DOHC build idea.
- Replies: 33
- Views: 15926
That's great to hear. I was curious to see where your progress was since I was going that same direction. Kinda bored of the stock untuned 2.0L R/T. I got an 01 2.4l pt head with exhaust mani. I'm hard pressed on the intake aswell as getting the head decked for 10.0CR. Been sitting since labor day t...
- Mon Dec 01, 2014 12:25 pm
- Forum: General 2nd Gen Discussion
- Topic: Gas Mileage
- Replies: 75
- Views: 24417
Well, My Neon Is Still Only Giving Me 150 Miles Per Tank =/ It Runs Great But IDK What Else I Can Do That's lousy MPG for a Neon. :( My guess is that you have a combination of factors, "stacking up". - Tire pressures - Dirty spark plugs - O2 sensors are 'marginal' (but not bad enough to set a code)...
- Sun Nov 16, 2014 9:51 pm
- Forum: Naturally Aspirated
- Topic: 2.0 DOHC build idea.
- Replies: 33
- Views: 15926
- Fri Oct 24, 2014 10:41 am
- Forum: Naturally Aspirated
- Topic: Ghetto blaster ready!
- Replies: 24
- Views: 10181
I am going to start a 2gn ghetto blaster soon to replace that one tho Why? The 1st gen manifold is better then the 2nd gen one. http://blog.modernperformance.com/swapped-a-second-gen-neon-intake-manifold-and-tb-onto-a-first-gen-neon-picsdyno-results :thumbup: It speaks for itself but I'll say it an...
- Thu Oct 23, 2014 8:23 pm
- Forum: General 2nd Gen Discussion
- Topic: Greenhouse big crash at Pacific Forest Rally
- Replies: 18
- Views: 5834
- Thu Sep 18, 2014 8:34 pm
- Forum: Engine
- Topic: Exhaust popping at idle like if decel.
- Replies: 4
- Views: 2206
how are the plug wires? Possible cross firing situation? I still say do a compression check, just to eliminate that possibility. Plugs and wires are new. Just replaced saturday night. Well I just did a compression check and I'm a little confused on the results. Cyl 1-165, Cyl 2-175, Cyl 3-175, Cyl ...
- Thu Sep 18, 2014 10:20 am
- Forum: Engine
- Topic: Exhaust popping at idle like if decel.
- Replies: 4
- Views: 2206
- Wed Sep 17, 2014 10:52 pm
- Forum: Engine
- Topic: Exhaust popping at idle like if decel.
- Replies: 4
- Views: 2206
Exhaust popping at idle like if decel.
Okay guys bear with please. 04 full RT swap. I recently had a run in with an improper COP ign setup which caused my pcm to go stupid setting the p0351 over 20 times for about 12mi and misfiring on cyl1-2-4. Junked that and now I'm back on a stock coil. Now since letting it sit for 3 wks I can hear p...
- Wed Jul 23, 2014 8:21 pm
- Forum: General 2nd Gen Discussion
- Topic: Gas Mileage
- Replies: 75
- Views: 24417
- Wed Jul 23, 2014 12:57 am
- Forum: General 2nd Gen Discussion
- Topic: Gas Mileage
- Replies: 75
- Views: 24417
- Wed Jul 16, 2014 8:18 pm
- Forum: General 2nd Gen Discussion
- Topic: Gas Mileage
- Replies: 75
- Views: 24417
- Wed Jul 16, 2014 7:32 pm
- Forum: Picture Post
- Topic: Official Carlisle 2014 Picture Thread
- Replies: 30
- Views: 13081
- Sat Jul 05, 2014 1:24 pm
- Forum: Progress/Project Log
- Topic: Hudson_Neon's Build... Oops...
- Replies: 409
- Views: 82938
- Sun Jun 29, 2014 9:12 pm
- Forum: Drivetrain
- Topic: Tabs on TOB
- Replies: 8
- Views: 5074
- Sun Jun 29, 2014 1:03 am
- Forum: Progress/Project Log
- Topic: New Build Not A Neon But Close
- Replies: 6
- Views: 3024
- Sat Jun 28, 2014 6:02 pm
- Forum: Drivetrain
- Topic: Tabs on TOB
- Replies: 8
- Views: 5074
- Sat Jun 28, 2014 5:59 pm
- Forum: Progress/Project Log
- Topic: Hudson_Neon's Build... Oops...
- Replies: 409
- Views: 82938
- Mon Jun 09, 2014 1:40 pm
- Forum: Engine
- Topic: An MTV question. They aren't opening
- Replies: 6
- Views: 2766
It should only activate when it is at WOT, except below 4900 rpm and above 3000. They are normally closed until WOT is sensed. Even in the RPM windows, with the factory PCM controlling them, they should be closed all the time if a WOT signal is not received from the TPS. So if the TPS voltage is of...
- Sun Jun 08, 2014 5:47 pm
- Forum: Engine
- Topic: An MTV question. They aren't opening
- Replies: 6
- Views: 2766
I had his personal 04-05 pcm for almost free at last yrs modern meet. Said he used for reference tunes. The post in engine section 'p2302 and p2305 giving me hell' was all my problems when it died. Sent it to WA and Kevin said it had a dead driver for the ign coils. ;_; I just got this r/t pcm vin m...
- Sun Jun 08, 2014 1:04 pm
- Forum: Engine
- Topic: An MTV question. They aren't opening
- Replies: 6
- Views: 2766
An MTV question. They aren't opening
They were working up until 2 days ago. Now it feels like it's struggling above 5k rpms. When I had my Syked r/t pcm you knew they were open with IGN on( they slammed open), and IGN off (you heard them slam shut). Now IGN on I hear nothing. I only hear them close when I'm WOT (KOEO) and IGN off. No v...
- Wed Jun 04, 2014 12:46 am
- Forum: Engine
- Topic: P2302 and P2305 Giving me hell
- Replies: 31
- Views: 9026
Yeah I'd never seen that before until I did my rt motor/trans swap. Lol I cracked 3 coil packs. The msd didn't crack, it just pooped itself. I'd love to finally get my dream car (89 Toyota supra) but I wont quit my neon. My friend has went through about 5cars and a bike. All foreign and his shifter ...
- Tue Jun 03, 2014 1:26 pm
- Forum: Engine
- Topic: P2302 and P2305 Giving me hell
- Replies: 31
- Views: 9026
Sorry to hear that man. Sounds like your giving up alil early to me. I've only owned my one neon for 4yrs now (first car I ever bought). I've only ever had mounts breaking lol. The one major problem was me replacing a motor due to flood hydrolock 2yrs ago. I just started having these pcm problems bu...
- Mon May 19, 2014 8:50 am
- Forum: Audio / Security / Electrical
- Topic: Anyone got a hidden headunit?
- Replies: 8
- Views: 4388