2GN.ORG

I swapped the socket from the drivers side and it still didn't work, the socket is good. There is no power coming from the plug that connects to the socket, I checked it with a test light. Could the wire have shorted out coming out of the mfs plug?

Hey guys, need some help trying to figure out the problem with my turn signal light. My front passenger turn light does not work. I've checked the bulb and switched it with the drivers side bulb and still no luck. If I disconnect the rear passenger bulb, the dash panel arrow clicks normally but stil...

i have a 2004 dodge neon se, when I turn on the ac on the low speed it throws out too much air as if it was on high, is there anyway to adjust the quantity of air coming in?

Folgers Coffee no bull, I left the window in my neon open when it was raining and when it dried up it stunk real bad. Got a cup off Folgers coffee, not mixed and ready just the powder and put it in the center over night. Next day threw out the coffee and smell was gone. Try it!

well after all this time i finally got it fixed, instead of being a tranni rebuild it ended up being the wire connected to the speed sensor, only cost me 210 :D Have you contacted the dealer that told you that you needed a trani and demand your diagnostic charge back? If they hassle you contact Chr...

well after all this time i finally got it fixed, instead of being a tranni rebuild it ended up being the wire connected to the speed sensor, only cost me 210

^^^^ I gave up on my dealer, from what i saw they dont know what they were doing. cleared the code, changed the speed sensor, test drove it. told me i need a tranni rebuild. Im taking it to Cottman transmissions so they can do an external diagnostics

thats what im thinkin occasional demons, sorry bout postin twice its just i want to be exactly sure my tranni is gone before i spend that much money on it and it ends up being something electrical or on the exterior of the tranni

after being at my dealer i really doubt they know what they're doing, all they did was tell me the obvious, they cleared the code, test drove it and told me its not shifting gears. changed speed sensor and drove it again, same thing not shifting gears. dealers says my tranni needs to be rebuild.

getting code p0731 Incorrect first gear Ratio? anything to fix this? or do i really need a transmission rebuild like tranni shop says? speedo and odometer not workin, already replaced input and output speed sensors. 2004 Neon Es Atx 46k miles

my tranni is supposably bad and needs replacing, been looking around and $2400 for a new tranni is too much but found a couple rangin from 30k miles to 50k miles same year and model for $400-$600. anything i should be looking out for, suggesions? comments?

just got back from the dealer and got bad news...appearantly my tranni needs to be replaced. the technician cleared the codes and drove it, said its not shifting out of gear. codes appeared again being p0731(Incorrect 1st gear ratio) and p01790 (Fault immediatly after shift). Next he replaced the sp...

ill take it to the dealer tomorrow, so from everything i've read and all the help i've been getting from everybody here i'd say its not the transmission like the tranni shop told me

so is my best bet is to just take it to the dealership

so should i start looking at the solenoid or is my trani really dead?

replaced the input and output speed sensors but still the same, anyone please able to help?

i took it to a transmission shop to see what they would say and he told me that p0700 is something wrong with the tcm electronically and that p0731 is incorrect 1st gear ratio which is something is wrong with the transmission internally and i need to rebuild it, which would cost me $2,600. I'm think...

thank you for your reply, i'm thinking its the speed sensor too, not sure if its the output or input speed sensor though. i know they're located under the airbox but one is bigger than the other one so not sure which one is which either. appreciate any more help i can get and merry christmas everyon...

P0731 is Incorrect 1st gear ratio which is causing p0700. my speedometer and fuel gauge dont work. Could it be the output/input speed sensor? a Fuse? can i do it myself or do i need to take it to a tranny shop and is it going to be expensive?