why code P0522??

daaboots · Post by **daaboots** » Fri Jul 14, 2006 6:32 pm

Has anybody else gotten this CEL code?

P0522 Engine Oil Pressure Sensor/Switch Circuit Low Voltage

Came on then went away. Does that mean the oil pressure is low? I checked and i have lots of oil and the filter was changed last oil change.

Any thoughts?

03sxt · Post by **03sxt** » Fri Jul 14, 2006 7:27 pm

daaboots wrote:Does that mean the oil pressure is low? I checked and i have lots of oil and the filter was changed last oil change.

Mine did it when I was like 1.5 quarts low.

BlackRoseRacing · Post by **BlackRoseRacing** » Fri Jul 14, 2006 8:30 pm

Is your switch leaking around the area where the plastic meats the metal?
The oil pressure switch is VERY common to go bad....

daaboots · Post by **daaboots** » Fri Jul 14, 2006 9:16 pm

Oil level is right at full.

Not sure if the sensor is leaking. Not too sure where it is actually

Panhead · Post by **Panhead** » Fri Jul 14, 2006 9:58 pm

daaboots wrote:Oil level is right at full.

Not sure if the sensor is leaking. Not too sure where it is actually

the sensor would be in front of the block, pass. side.

daaboots · Post by **daaboots** » Fri Jul 14, 2006 10:04 pm

03neonSE wrote:
daaboots wrote:Oil level is right at full.

Not sure if the sensor is leaking. Not too sure where it is actually
the sensor would be in front of the block, pass. side.

cool thanks man.

I reset the PCM and it hasn't come back yet. I'm hoping it was just some kind of weird 1 time thing. donno.

BlackRoseRacing · Post by **BlackRoseRacing** » Sat Jul 15, 2006 6:21 am

the sensor would be in front of the block, pass. side.

Its on the drivers side rear of the block....

Panhead · Post by **Panhead** » Sat Jul 15, 2006 12:56 pm

BlackRoseRacing wrote:
the sensor would be in front of the block, pass. side.
Its on the drivers side rear of the block....

argh...

its right near the exhaust mani.

2GN.ORG

why code P0522??

why code P0522??

Re: why code P0522??