Page 1 of 1
rotors??
Posted: Tue Jul 18, 2006 6:01 am
by lvlistchif
do you have to adjust anything for your rotors to fit cause it seems like my rotors are a bit to big and dont fit. about a centimeter bigger than stock ones. is there anyway to fix this or they sent me the wrong size?
Posted: Tue Jul 18, 2006 6:16 am
by BlackRoseRacing
Are you reffering to te rotor not fitting between the pads in the caliper or are you talking about the rotor not fitting on the hub...more details are needed
Posted: Tue Jul 18, 2006 6:28 am
by lvlistchif
it wont clear the hub i think its called, like 2 parts that stick out and the caliper and brake pads sit in.
Posted: Tue Jul 18, 2006 11:38 am
by J8t4m
Maybe take a couple pictures ?
Posted: Wed Jul 19, 2006 6:25 am
by BlackRoseRacing
it sounds to me like your trying to stuff an srt rotor onto a non srt setup. The Srt rotors are 3/4inch wider(bigger) than the non-srt, wich means your going to need srt knuckles to make them fit...
Posted: Fri Aug 04, 2006 3:05 pm
by lvlistchif
would i only need to replace the front brake system or do i nee to replace the rear for them to fit to? i didnt test the rear.
Posted: Fri Aug 04, 2006 4:09 pm
by kc2005ptgt
all... front and rear.
Posted: Fri Aug 04, 2006 4:12 pm
by rice_eater
lvlistchif wrote:would i only need to replace the front brake system or do i nee to replace the rear for them to fit to? i didnt test the rear.
the rears should fit since they are the same between R/T neons and SRTs, as long as you actually have disks in the rear to begin with
if this is a stock neon with rear drums, you have no rear caliper built into the rear knuckles, so while you can put the rotor in, there wont be anything to sqeeze it and make it stop