srt shifter measurment

TNK · Post by **TNK** » Sun Mar 11, 2007 6:35 pm

i knwo this is an odd request, but im lookign for a measurement of the notch on an SRT shifter assembly. i wanna mod my shifter to use my SRT knob ive got without it popping off all the time. here's a diagram for an explanation of what im needing..... id really like this to be as precise as possible....

Post by **racer12306** » Sun Mar 11, 2007 7:23 pm

I don't know if I still have that piece, as I cut it off. But it may be laying around on the garage floor. However, I won't even be able to try and find it till the weekend.

If you don't have an answer by then, I will try and find it and give you a measurement. I should be able to give you a measurement to the thousandths place, .xxx.

TNK · Post by **TNK** » Sun Mar 11, 2007 7:49 pm

sounds good thanks bud. i planned on using a micrometer to measure my friends, but he says his knob wont come off....

Post by **Diablo0** » Mon Mar 12, 2007 7:12 pm

I'd help ya out but my extra shifter is packed away somewhere in a box

TNK · Post by **TNK** » Mon Mar 12, 2007 11:46 pm

oh well. thanks anyways, but i jerry rigged it with a couple wraps of electrical tape aroudn my chopped shifters shaft. then proceeded to pound it on with the heel of my hand. its on good now.

neonpla · Post by **neonpla** » Tue Mar 13, 2007 1:46 am

dude, just jb weld the knob on there... the knotch dont hold for shit.... mine always used to pop off.

outkast · Post by **outkast** » Tue Mar 13, 2007 1:56 am

2/32nds is what i got

MoxHair · Post by **MoxHair** » Tue Mar 13, 2007 10:43 am

neonpla wrote:dude, just jb weld the knob on there... the knotch dont hold for shit.... mine always used to pop off.

word

TNK · Post by **TNK** » Tue Mar 13, 2007 8:19 pm

it hasnt moved yet.

btu thanks for the tips and thanks for the measurement outkast