Page 1 of 1
srt shifter measurment
Posted: Sun Mar 11, 2007 6:35 pm
by TNK
i knwo this is an odd request, but im lookign for a measurement of the notch on an SRT shifter assembly. i wanna mod my shifter to use my SRT knob ive got without it popping off all the time. here's a diagram for an explanation of what im needing..... id really like this to be as precise as possible....
Posted: Sun Mar 11, 2007 7:23 pm
by racer12306
I don't know if I still have that piece, as I cut it off. But it may be laying around on the garage floor. However, I won't even be able to try and find it till the weekend.
If you don't have an answer by then, I will try and find it and give you a measurement. I should be able to give you a measurement to the thousandths place, .xxx.
Posted: Sun Mar 11, 2007 7:49 pm
by TNK
sounds good thanks bud. i planned on using a micrometer to measure my friends, but he says his knob wont come off....
Posted: Mon Mar 12, 2007 7:12 pm
by Diablo0
I'd help ya out but my extra shifter is packed away somewhere in a box
Posted: Mon Mar 12, 2007 11:46 pm
by TNK
oh well. thanks anyways, but i jerry rigged it with a couple wraps of electrical tape aroudn my chopped shifters shaft. then proceeded to pound it on with the heel of my hand. its on good now.
Posted: Tue Mar 13, 2007 1:46 am
by neonpla
dude, just jb weld the knob on there... the knotch dont hold for shit.... mine always used to pop off.
Posted: Tue Mar 13, 2007 1:56 am
by outkast
2/32nds is what i got
Posted: Tue Mar 13, 2007 10:43 am
by MoxHair
neonpla wrote:dude, just jb weld the knob on there... the knotch dont hold for shit.... mine always used to pop off.
word
Posted: Tue Mar 13, 2007 8:19 pm
by TNK
it hasnt moved yet.
btu thanks for the tips and thanks for the measurement outkast