Plastic tang on coil pack snapped off.

jmr · Post by **jmr** » Sun Mar 18, 2007 3:07 pm

I slid that red clip out of the coil pack wire connector and one of the tangs snapped off the coil pack. Anybody else had problems with the coil pack connector ?

lvlistchif · Post by **lvlistchif** » Sun Mar 18, 2007 3:30 pm

yea ive snapped like 3 connectors off different spots, it never did anything, none came lose or anything, been running fine for over 8 months without the clips, it happened when i was putting my new motor in when i hydrolocked my last one

jmr · Post by **jmr** » Sun Mar 18, 2007 4:02 pm

I drilled a very small hole thru the top of connector about a 3/16 from the end. Then put a short #4 sheet metal screw so that it hits the coil pack and locks into it. It doesn't go into the coil pack but act like a set screw and locks against it.

Damn plastic tangs always snap off. There isn't any tension on this connector just making sure it doesn't disconnect.

Post by **racer12306** » Sun Mar 18, 2007 4:03 pm

good thinking

kc2005ptgt · Post by **kc2005ptgt** » Wed Mar 21, 2007 2:03 pm

OH NO!!!!!!!! You didn't break it did you??? OH NOESSSS!!!!111!!!!1one!!!!1eleventythousandone!!! J

ust kidding, good thinking, I broke mine long time ago!