2GN.ORG

yesterday i came out of work and had a flat i tried changin the tire but 1 lug nut was on way to tight when i tried taking it off it snaped the whole nut that its attached to and now i cant get the lug off im trying to hammer it with a chisel andbody else got any ideas what to do?

I believe you have to use an impact gun to get it off.

the lug is still tight on the nut if i try turning it with the wrench it just keeps turning the nut its not doin anything its not budging

I've broken 7 wheel studs in a year.. so good luck its gone and you'll have to buy new lug nuts too.

i know that im not asking that but what i am asking is the tire wont come off because the stud broke off n the lug is still on the stud and its on tight and i cant get the lug off

Big Ass breaker bar

im tryin with things i got a tryin a chisel and a hammer think itll work if i hit it on the inside on an angel

I usually just say the hell with it and get a big breaker bar and pull up and down until it snaps. Eventually the metal will heat up and pop

can i use any tipe of pipe to snap it off

put the pipe on the end of the Breakerbar. It's best to use a Impact Gun, but if it's all you got

i dont even know if i have a breaker bar

i got it off with a big chisel n mallet