60mmtb screws

onewickedkid05 · Post by **onewickedkid05** » Tue Oct 23, 2007 3:15 pm

So i got a used 60mm tb but i dont have the aftermarket screws to fit everything together....anyone know if i can get them at home depot and what ill need

kevo · Post by **kevo** » Tue Oct 23, 2007 3:19 pm

i believe its a metric bolt with an allen key head but i forgot exactly which one it is. If i were you i would just take the TB with you to the hardware store and start looking through their bolts. Smaller hardware shops usually have their bolts in trays, this way you can just pick one up and test fit it.

Post by **Diablo0** » Tue Oct 23, 2007 3:41 pm

Who made the TB? Lorenzo or MPx (ZZapp)? If so you might give them a call to see if they have any laying around or can get a hold of for you if you can't find any in a hardware store.

onewickedkid05 · Post by **onewickedkid05** » Tue Oct 23, 2007 8:20 pm

installed everything worked out ok went to lowes and got some new screws...Does anyone elses idle a little wierd. It seems likes its idling a little high not bad though but i do love this new throttle body.

And does anyone know what to do with the egr cable should i just slap a breather on the end since this throttle body doesnt have a thing for it

kevo · Post by **kevo** » Tue Oct 23, 2007 9:21 pm

onewickedkid05 wrote:installed everything worked out ok went to lowes and got some new screws...Does anyone elses idle a little wierd. It seems likes its idling a little high not bad though but i do love this new throttle body.

And does anyone know what to do with the egr cable should i just slap a breather on the end since this throttle body doesnt have a thing for it

if you are idling too high, adjust the scew until you get your desired idle. Don't forget to reset your ecu after adjusting the idle.