LDP wiring diagram

blackflame · Post by **blackflame** » Fri Jun 04, 2010 1:16 pm

EDIT: Found the diagram I needed! Look below to see what I found with the plugs.

Here is what I soldered together:

SRT White/DG to Neon White/DG
SRT Orange to Neon Yellow
SRT Black to Neon Blue/WT

That didn't seem to get rid of the CEL so I'm just going to reground the ground wire and run it to its factory spot.

Heres what I have:

SRT Plug:
Pin #1: Black - Ground
Pin #2: Orange - NVLD Switch Signal (goes to C3 plug)
Pin #3: White/DG - NVLD Solenoid Circuit (goes to C3 plug)

Neon Plug:
Pin #1: EMPTY
Pin #2: Blue/WT - Fuse #10
Pin #3: White/DG - LDP Solenoid Control
Pin #4: Yellow - LDP Switch Sense

Thanks guys!

MyNeonSaysHi · Post by **MyNeonSaysHi** » Fri Jun 04, 2010 1:23 pm

Natural Vacuum Leak Detection Pump. Thats a mouthful. So you are running the reg neon NVLD?

blackflame · Post by **blackflame** » Fri Jun 04, 2010 1:26 pm

Well its an SRT swap. I have the infamous CEL lights for not having the NVLD. Since mine is a 2002 I'm running the LDP pump instead of the NVLD pump. I have the NVLD pump in hand but I need to figure out what these LDP wires are first.