Page 1 of 1
Dyno Sheets
Posted: Tue Feb 07, 2006 2:29 pm
by J8t4m
Hey all
Post your dyno sheets here along with your Mods you were running at the time . . . Maybe we can cut down on the "how many Horsepower will this give me" posts
Ill be posting mine once i get my UDP and TB
Posted: Tue Feb 07, 2006 2:34 pm
by nodestiny
Good luck... Dyno = spendy! And for some, hard to find localy. Once i get closer to being "done" ill get dynoed, mainly to put evidence against NGC discusions (hopefully!). But it would be nice to have SOME if any dyno sheets up here...
Posted: Tue Feb 07, 2006 3:22 pm
by quicksilvr
nodestiny wrote:Good luck... Dyno = spendy! And for some, hard to find localy.
Exactly.
I wish I could have already had my car to the dyno at least once, better if twice. But alas, none at all. As soon as it does actually happen though, I'll definately post it up.
Posted: Tue Feb 07, 2006 5:14 pm
by CrashTeam
^ Dude theres a Dyno right outside of quincy, $45 for three pulls...
Posted: Tue Feb 07, 2006 5:57 pm
by unsuper man
custom turbo kit.
14.1 @ 99.7
Posted: Tue Feb 07, 2006 6:36 pm
by Diablo0
Black car
AEM CAI
Thermal RD muffler
Mopar Perf Wires
Apexi' Grounds
Unorthodox UDP
MPx 60MM TB
SSR Comp 17x7.5 semi-forged wheels (13.3lbs each).. not sure on the weight of the tires... I've been meaning to weigh them again.
Posted: Tue Feb 07, 2006 6:48 pm
by OB
unsuper: less than 100whp WITH turbo? somethings badly wrong...
diablo: those wheels are LIGHT how much u pay for em? any more info on light wheels would be great, the wheels i was lookin into are over 20lbs @ 17x7, and if i could save 7 lbs per wheel (almost 30lbs total) that would totally be worth it. nice dyno btw i wanna do one sometime!
Posted: Tue Feb 07, 2006 6:55 pm
by Diablo0
Be prepared to spend about $1500+ just for 4 wheels then... unless you go rotas.. they're a little cheaper aren't forged.
want more info pm me as to not jack this thread.
Posted: Tue Feb 07, 2006 9:09 pm
by 01rtgurl
unsuper man wrote:
custom turbo kit.
14.1 @ 99.7
was that a mustang dyno? dynojet????
Posted: Tue Feb 07, 2006 10:04 pm
by quicksilvr
CrashTeam wrote:^ Dude theres a Dyno right outside of quincy, $45 for three pulls...
Hahaha, I didn't know that. I've never been to Quincy in my life. And it's a 1 hour drive still. Kirksville is the sticks, but I guess I'm used to it.
Posted: Wed Feb 08, 2006 7:59 am
by weber
SRT Turbo setup, custom IC piping. SRT stock exhaust.
Also, this is on a Mustang Dyno, rates 15% lower than DynoJet.
so in otherwords, 174.8 HP with 201 ft lb. @ 5 PSI
