2GN.ORG

Posted: **Mon Apr 17, 2006 7:39 pm**

Oh man i am sorry to post a header topic but i couldnt find what i was looking for on this forum or the neons.org forum. My question is from what i read no one can tell me exactly what it takes to put a pacesetter header on a stock exhaust. My other question is what does it take to put the obx header on minus the downpipe. Thanks for any help.

Posted: **Mon Apr 17, 2006 8:27 pm**

uhhh....
1. take the exhaust manifold off.
2. install header

*edit* oh, i forgot the gaskets, make sure you put the gaskets on.

Posted: **Mon Apr 17, 2006 9:28 pm**

^dont forget to take the stock exhaust off first haha jk

its a straight bolt on (assuming the pacesetter actually fits). that company is known for making less than quality products... same deal for the obx. only a longtube header would require custom exhaust/downpipe section. the stock exhaust should bolt right up to the new manifold. btw youre doing header BEFORE exhaust? odd..

Posted: **Mon Apr 17, 2006 10:03 pm**

I have a full catback. I just need to finish up the exhaust by putting the header on. How much work does it take for pacesetter header to fit i have heard that i have to cut a flange off.

Posted: **Mon Apr 17, 2006 10:31 pm**

i can tell you from expierence that trying to use the obx header without the downpipe is a holy pita.

Posted: **Tue Apr 18, 2006 10:53 am**

jeremy answered my question.

Posted: **Sun Apr 23, 2006 11:00 pm**

how did the install go? i might have to go through this soon and am not lookin forward to it

Posted: **Mon Apr 24, 2006 10:29 am**

I dont know yet i got my header an i tryed to unbolt the manifold from the downpipe and realized that bolts are not coming out. Guys i need some help how do i get them apart and how do i get the downpipe out of the car so i can cut it.

Posted: **Mon Apr 24, 2006 1:06 pm**

IIRC the bolts are welded or pressed on there... take the nuts off, then slide the dp out.