2GN.ORG

ok,so i'm putting these in this weekend and i've never done this before. just wondering if there is any chance of snapping the bolts when i tighten them up a-la valve cover bolts, or is that not something to worry about. i dont think so but its better to be sure.
i'll be using hand tools by the way..yeah fun..ha. and i assume useing a jack to brace the engine even if i do one at a time is a good idea, yes?

thanks,
harry

http://forum.2gn.org/viewtopic.php?t=4978

As it says there

nodestiny wrote:Remove the bolt, push the insert in (goes in well after a good push) and bolt it back up with washer. Must be pretty dumb to mess this install up...

You shouldn't break the bolts. You wont need to brace the engine with a jack either. Just do one at a time and you'll be ok

cool man, thanks

if i wouldve known that these things were so simple to put in i wouldnt have let them sit around for 3 months,ha.

p.s. i hate push pins

harry

you have been pm'd