2GN.ORG

could anyone tell me how to replace a head gasket on an 00 es? like a link or a short step by step?

take ur car to a shop, pull your pants down, bend over

Here a link to the 2000 factory engine service manual....

http://www.ertyu.org/steven_nikkel/neon ... /EPL_9.pdf

I didn't check but would assume all you need to know is in there.

lvlistchif wrote:could anyone tell me how to replace a head gasket on an 00 es? like a link or a short step by step?

Head to your local Autoparts store, they should have the Haynes or Chilton Service Manual. Thats the easiest way to see how with illistrations and step by step instructions. Should cost you less than $20 or so.

Buy a Chilton's guide and spend the $$ on a copper gasket. It is involved, but not scary crazy to do. I want to do it to mine.

eastwoodsn352 wrote:take ur car to a shop, pull your pants down, bend over

You are SO wrong - I laughed out loud though.


Yeah, a chiltons is a must for this, especially if you are asking how too... you should be able to do it, but make sure you read, reread, and read again to make sure you miss nothing, and have everything you need before you start. Once more, make sure you have all you need before you start!

EVERYTHING before you start. Nothing worse than trying to get factory parts on a Sunday evening when you are half cocked on Coors Light from wrenching all day...

^^^
Been there done that

why pay for the manual when you can find them all online for free!

http://www.ertyu.org/steven_nikkel/neon.html

tamadrumr88 wrote:why pay for the manual when you can find them all online for free!

http://www.ertyu.org/steven_nikkel/neon.html

Sticky?

YEAH my car is on of 586 built in 02....
No I want to try to find a base 02 ACR in red or white!
Definately good info!!!
But there is no free manual listed at that link