2GN.ORG

Posted: **Sat Jun 23, 2007 11:26 pm**

Does anybody have the obx long tube header? it looks to be a nice piece. also does it fitr a magnum? thanks for the input guys.

Posted: **Sat Jun 23, 2007 11:41 pm**

I would like to know the primary and collector sizes if anyone knows. I heard it was a knockoff of the TTI header.

Posted: **Sun Jun 24, 2007 12:03 am**

i know the obx stuff is pretty good. i just got the intake and the construction was pretty good for like 70 shipped.

Posted: **Sun Jun 24, 2007 1:04 am**

TTI FTMFW

Posted: **Mon Jun 25, 2007 11:33 am**

Unless they have just come out with a true LTH, AFAIK OBX only makes a shorty header like the Pacesetter, but has an "extension piece" that acts as a 'cat delete' or test pipe of sorts. It's not a true LTH. Any links to this OBX LTH?

Later
Allex

Posted: **Mon Jun 25, 2007 11:55 am**

http://cgi.ebay.com/ebaymotors/OBX-St-S ... 9884QQrdZ1

If I was building up a nice streetable motor w/ a standard head I would give it a try.

Posted: **Mon Jun 25, 2007 12:31 pm**

i've been lookin into this header as well since its like half the cost of most other LTH's. I have the short-tube and have had absolutely no problems with it.. im hoping that header, with the 6 inch extension after the flange, will still get my high-flow cat, hot enough, since this setup will put it farther down the exhaust system...

only problem i could see with this, is the upper o2 sensor bung, looks like its off to the side, might be right against the firewall or coolant overflow bottle like that, not sure..

Posted: **Mon Jun 25, 2007 9:41 pm**

so this header will not fit the magnum motor?

Posted: **Mon Jun 25, 2007 11:53 pm**

should, might have to slot a few bolt holes, but should bolt up. patterns are the same, placement of the ports is different.