Mag cyl head question

daaboots · Post by **daaboots** » Fri Jul 06, 2007 10:46 am

If I was to get a bare mag head, could I use my non mag valves, rockers, etc, or are these parts not the same? What other seals and such would I need to buy new? I'd be getting an aftermarket cam and springs so I wouldn't use my non mag ones.

Thanks

Jamie · Post by **Jamie** » Fri Jul 06, 2007 12:04 pm

ok guy an answer to your question is yes most of your parts from your standard head will fit in the mag head...

here is a write up that was done that answers your every question... just had to type in Magnum head in the search block and it would have appeared

http://forum.2gn.org/viewtopic.php?t=19 ... +head+swap

good luck
J