Ebay Header???

04_yelneon · Post by **04_yelneon** » Sat Apr 12, 2008 11:13 am

I want to get a header and a downpipe for my 04, but i dont have alot of money like most of us. Iv always seen the header and downpipe combos on ebay. The brand I see most of the time is BBP. Is that brand descent? Its chrome, so Im sure it will chip off, but is the quality on these good? for $100 i dont expect miracles but some HP gain... Thanks guys!

INVUJerry · Post by **INVUJerry** » Sat Apr 12, 2008 11:26 am

That looks just like the OBX headers people used to get for their cars. They are alright, the finish wont come off, but they aren't the best headers for these cars. The OBX long tube's are good. Basically any long tubed header would be the best for our cars.

04_yelneon · Post by **04_yelneon** » Sat Apr 12, 2008 11:42 am

So somthin like the kirk racing header on Modern Performance?

NickKo · Post by **NickKo** » Sat Apr 12, 2008 2:56 pm

Keep in mind that ANY header install is not going to be a 'direct-bolt in' swap, it's often going to be a pain in the arse, and require at least some modifications.... In my personal experience.

Then, I will spend a following weekend (or two, or three, or four) trying to 'adjust' my exhaust installation, or re-tighten something, or move something around because it's rubbing somewhere, etc.

So if you are going to spend the money.... and the EFFORT... to put on a header, make it worth your while !!

I'd check these boards and get as much information and read up as many reviews as possible before making a decision.

But that doesn't tell you anything about the quality and durability of the header .....
A cheap E-Bay header *may* not last as long, or *may* have more fitment issues (I am not saying that all Ebay stuff is bad).

It also depends on tools and equipment ... not everyone has a lift, or a welder.
If you had a lift and a welder, you could take the lousiest header and rework everything to fit O.K.
Rust and longevity is another story. Part of that is up to the buyer....

I have used hi-temperature Exhaust Manifold coating on a Pacesetter header, and it seems to hold up fine.

-Nick