2GN.ORG

So after ordering a cometic head gasket I read that they don't work with ngc engines.... Is this true? They should fit, but why don't they "work"?

As long as the gasket is for an '03-'04 2.0 it should work. The older gaskets are different, IIRC the NGC heads have revised oil or coolant passages. I think it was an oil feed? You could hold your old one up to the new to see if the holes can be changed enough in the gasket to accomidate the change. I believe there is a thread on modding the head to make them work, as long as the hole can be elongated slightly and still seal I think it will work. but without the two to compare ? I'm sure you don't want to tear your head off just to find out tho. I'm assuming by cometic (cosmetic) you're referring to the thinner style gasket?

No I mean Cometic.
https://www.horsepowerparts.com/index.p ... uct_id=132

I heard that the oil passages changed in only the late model dual cams like srts.

Is anybody using the cometic on their 03-05 2.0s that may know from experience?

occasional demons wrote: The older gaskets are different, IIRC the NGC heads have revised oil or coolant passages.

You're thinking of the DOHC/2.4L. All the 2.0L blocks have the same head gasket.

03blackrt wrote:You're thinking of the DOHC/2.4L. All the 2.0L blocks have the same head gasket.

My bad, I didn't recall correctly.

Then I don't know what the issue would be. Isn't the OEM head gaket also an MLS design? Other than the viton coating, what advantage does it have over the OEM piece?

"5014127AC Head gasket, all models - 2.0l sohc List Price $51.10"
But if you figure in the Mopar sealant the prices are about the same.
Edit: Compatibility
(click a row to view ALL products that fit)
Year(s) Make Model Engine
95-99 Chrysler Neon 420A (DOHC Neon)
95-99 Dodge Neon 420A (DOHC Neon)
Unless there is something different about 2000-up blocks? This is assuming that the DOHC uses the same gasket.

Apparantly it is thicker and stronger but don't quote me on that lol

As mentioned above, the SOHC(all) and early 2.0/2.4's all use the same head gasket...
I'm pretty sure 01+2.4's are the one's that are different because of the oil drain back hole being larger and oval'd....
That's why you can't put an early DOHC head on a late model block without mods...

Well once I get this head gasket I'll let you know how it fits up. This is the last thing I need for my build.

So pretty much the head gasket fits so for any of you crazy turbo or nitrous builders out there.... Theres a new head gasket out there for you

i used one on my r/t motor which was built 3 years ago. then it was offered in standard bore or .20 over bore. i payed $90 for mine back then.

For reference: the OEM gasket thickness is 0.045" installed thickness.
So basically you shaved .005" just by changing the gasket