Page 1 of 1
Cam Question
Posted: Tue Jun 10, 2008 12:20 pm
by Craz1000
when i change my clutch i am also thinking of going ahead and changing my timing belt and throw on a R/T cam
i heard the 01 R/T cam is more aggressive than the NGC R/T's if this is so can i throw on the 01 R/T cam without a problem or not because the 01 cam is actually cheaper than the NGC part
Posted: Tue Jun 10, 2008 1:07 pm
by Swordfish2Cowboy
Yes, the cams are interchangeable. The 01's were hotter and wore out easier.
Posted: Tue Jun 10, 2008 2:32 pm
by Wenuden
and change the water pump while you're doing the timing belt.
Posted: Tue Jun 10, 2008 3:07 pm
by spencersummerfield
replace trani fluid with Royal Purple.
Posted: Wed Jun 11, 2008 2:09 am
by kc2005ptgt
replace tensioner as well as water pump... and yes, 01 mag cam works on all neon models...SOHC that is.
Posted: Sun Jun 15, 2008 4:44 pm
by Craz1000
new question whats the most aggressive cam i can buy that dosent require changing springs and retainers
Posted: Sun Jun 15, 2008 4:47 pm
by Hudson_Neon
crane 12 or comp 200...
Posted: Sun Jun 15, 2008 5:22 pm
by Swordfish2Cowboy
Craz1000 wrote:new question whats the most aggressive cam i can buy that dosent require changing springs and retainers
Not worth it, IMO. From looking at just the numbers, I wouldn't spend my money on either of those and just upgrade everything.
Posted: Sun Jun 15, 2008 6:47 pm
by INVUJerry
Pretty much the 01 R/T, the comp200 and the crane 12 are about the same level, with the 02-04 R/T cam a little behind. You don't need to change springs or anything.