crack in borla header

v95 · Post by **v95** » Sat Mar 28, 2009 1:00 pm

i just looked at my borla header on tube number three while changing the oil and it has a small crack in it. is there a weld patch that i can use to stick over it to fix that. so i don't have to pay big bucks to get fixed

Post by **racer12306** » Sat Mar 28, 2009 3:05 pm

Just weld up the crack with appropriate filler wire.

v95 · Post by **v95** » Sat Mar 28, 2009 3:36 pm

where can i find it. is it at like autozone or special order

Post by **racer12306** » Sat Mar 28, 2009 3:38 pm

a welding supply store.

03blackrt · Post by **03blackrt** » Sat Mar 28, 2009 4:07 pm

It shouldn't cost much more than $20 to weld a crack, esspecially since it's not cast metal.

v95 · Post by **v95** » Sat Mar 28, 2009 4:07 pm

ok cause there one right by my school sweet.

jgs11 · Post by **jgs11** » Sat Mar 28, 2009 4:24 pm

make sure they weld it with stainless

excon · Post by **excon** » Sun Mar 29, 2009 8:32 pm

doesn't borla offer an awesome warranty?

Post by **occasional demons** » Sun Mar 29, 2009 9:38 pm

1 million miles. But if you don't have a receipt, I'm sure you might have trouble making it stick.

I'm sure it would be voided by in improper tune also.