This is the place to ask questions about your engine components like cams, valves, pistons… just anything that is generally "engine" specific. This also includes questions about exhaust systems such as exhaust manifolds, piping size, mufflers, ect...
-
DR. GONZO
- 2GN Member
- Posts: 821
- Joined: Sun Feb 15, 2009 6:13 pm
Post
by DR. GONZO » Sat May 09, 2009 3:38 pm
what's the diameter of the pipe on a 2004 neon r/t stock exhaust?
Official "I'm Going to Drive My Neon till it Dies" Club #000062
-
DR. GONZO
- 2GN Member
- Posts: 821
- Joined: Sun Feb 15, 2009 6:13 pm
Post
by DR. GONZO » Sat May 09, 2009 3:58 pm
tanks
Official "I'm Going to Drive My Neon till it Dies" Club #000062
-
Swordfish2Cowboy
- 2009 Silver Contributor
- Posts: 2693
- Joined: Sat Aug 25, 2007 7:06 am
- Location: Sandusky, Ohio
Post
by Swordfish2Cowboy » Tue May 12, 2009 1:20 am
03blackrt wrote:2.25"
All the way around. Not like those SRT-4s that have the 2" pipes around the cat.
On a semi-related note, I've two rust holes in my muffler.
-
Fuzzyneon
- 2009 Silver Contributor
- Posts: 4872
- Joined: Fri Oct 26, 2007 12:48 am
- Location: Waterford works ,NJ
Post
by Fuzzyneon » Tue May 12, 2009 3:05 am
Swordfish2Cowboy wrote:03blackrt wrote:2.25"
All the way around. Not like those SRT-4s that have the 2" pipes around the cat.
On a semi-related note, I've two rust holes in my muffler.
2.25 inch holes?
Member of Spork Racing
2002 Dodge Neon
Frankenstien
-
occasional demons
- Junior Admin
- Posts: 20064
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
Post
by occasional demons » Tue May 12, 2009 5:03 am
Bill
Probably shouldn't listen to anything your penis says, that guy's a dick.
Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
Too much time spent here is a sign of a bad case of Ownaneonvirus.
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
