Page 1 of 1
motor mounts and trani mounts
Posted: Wed May 20, 2009 11:05 am
by v95
hey was just wondering and did not see a post for it et but is there a difference in length between a non srt and srt engine mounts and trani mounts and if so how could i fab. the srt ones to fit my non srt neon
Posted: Wed May 20, 2009 12:25 pm
by Boyscoutgonebad
motor mounts are interchangeable, transmission mount is not.
Posted: Wed May 20, 2009 12:29 pm
by occasional demons
I think the passenger side mounts/TS will all interchange, but there are different PN#'s between the ATX and MTX. Prolly different rubber hardness?
The SRT MTX mount is different and I doubt it would be worth the effort.
The SRT center pass. side MM is heavier duty, but is a direct bolt in.