2GN.ORG

well the other day i noticed my timing belt looked to be wet so i was like wtf and decided to touch it to see what the liquid was. upon touching the belt it moved side to side like when there is no tensioner on the car so i checked the slag on the belt and it was so loose that if i wanted to i could pull the belt of the cam gear with one finger. i was a block away from home so i idled the car home when i got home i checked it and it was fine really tight and no problems so i was puzzled. well i now noticed that some times itll be loose and sometimes itll be tight what could be the problem would the tensioner just be loose or broken any help would be appreciated thanks

ummmmm... the timing belt is covered.. how did you see it?

Prolly running w/out the cover.

ya no cover

I think the tensioner is the only part that could cause that, unless the belt stretched. How old is that tensioner?

its the one that came with the car its an 04 but is this a common problem with belt tensioners or what

whatever caused this, you should be very carefull and find/fix the problem before you bend your valves badly

how do you know if the valves are bent

do a compression test you can find out if the engine is bad.

how should the compression be like 150 all the way across right

If it was still running fine, and no CEL, then I doubt there has been any damage yet. I would just replace the tensioner and call it a day. IIRC NGC will throw a CEL if the cam timing is less than a tooth off.

P1345 Crankshaft Position (CKP)-Camshaft Position (CMP) Correlation

That would be my guess.

well the car is running fine no problems and well i got tired of playing the guessing game so i tore the car apart and messed with the tensioner it was just a little bit loose so i tightened it up and now its fine thanks for all your help guys

Glad to hear it was an easy fix, must be a lot easier with no cover on there.

oh hell yeah i removed it when i droped in the pnpd head