2GN.ORG

ive searched but my search foo isnt to good! ok i have a aem cai installed on my car but i can not get the air temp sensor that plugs into the pipe before the TB to stay in the pipe i have even tried super glue but that doesnt work either? the person i bought the cai from tried silicone but he said that didnt work to long and he ended up ziptieing it? what is the best way to make this sensor secure? i dont really wanna zip tie it down!

My CAI doesn't have any where to plug the sensor in so all I did was drop it down the hole into the inner fender where the filter sits.

hmm. my cai has a hole for the sensor. i dont really wanna just leave that hole open, hmm. ill keep trying stuff i guess, something is bound to work!

Plug the hole, and tie the sensor out of harms way. As long as it is getting a temp reading near the air inlet, it should be fine.

Or just wrap a little tape around the end of the sensor, just enough to make it fit nice and snug in the hole.

Put rubber bands around it