Stock to RT exhaust

This is the place to ask questions about your engine components like cams, valves, pistons… just anything that is generally "engine" specific. This also includes questions about exhaust systems such as exhaust manifolds, piping size, mufflers, ect...
Post Reply
GtozMb
2GN Member
Posts: 53
Joined: Tue May 05, 2009 6:29 pm

Stock to RT exhaust

Post by GtozMb » Sat Nov 21, 2009 11:43 am

I am switching my stock exhaust at the last rear joint from stock to the RT set up. Does anyone know the size of the inside dimensions of the RT at the joint (i think it flares out) and the inside demensions of the stock so I can get an adapter to join them?

Thanks in advance
Top
Broken Glass
2GN Member
Posts: 426
Joined: Mon Feb 05, 2007 7:56 am
Contact:
Contact Broken Glass

Post by Broken Glass » Sat Nov 21, 2009 12:15 pm

if you order a new RT exxhaust it comes with the proper adaptor, but its its used sorry i dont know the sizes
Image
Top
occasional demons
Junior Admin
Posts: 20067
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Sat Nov 21, 2009 1:36 pm

Standard SE/SXT exhaust is 2" at the joint. R/T is 2.25"

So I would guess a 2" I.D. X 2.25 O.D. bushing will do.

Search button turned up, using muffler + adapter:

viewtopic.php?t=33206

viewtopic.php?t=38984

viewtopic.php?t=33950
Bill
Probably shouldn't listen to anything your penis says, that guy's a dick.
Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
Too much time spent here is a sign of a bad case of Ownaneonvirus.

2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Top
GtozMb
2GN Member
Posts: 53
Joined: Tue May 05, 2009 6:29 pm

Post by GtozMb » Sun Nov 22, 2009 8:07 pm

Thanks guys
Top
Post Reply

Return to “Engine”