2GN.ORG

hey guys i have some ?s about the mani. with the butterfly does it really have to be in there, cuz fuzzyneon was telling me on his he ran it no butterfly and it ran fine, idk help me out

it will run fine but you will loose some mid range torque.

that fine im mostly highway neway above 4k and how do i mount my tb then..?

if youre putting it on a 2gn then you need to use the stock bellows tube or get an intake for the mag, or you can make one out of exhaust pipe i know someone on here atempted it i just don't know where it was at (mybe how to but im not sure)

all it pretty much is is a 90 deg. bend ill just buy a piece of 90 ic piping and make it work or make my own set up

not to thread jack.. but the piece that goes between the manifold and the throttle body is a 20 degree bend correct ?

no its a 45 degree bend 2.25 inch pipe.

ya its 45, I just did this. and it sucked.

DoubtedNeon wrote:ya its 45, I just did this. and it sucked.

It's supposed to suck.

But now, yours gets force fed.

lol. ^ Love this so much <3

acr wrote:no its a 45 degree bend 2.25 inch pipe.

oo snap. ok. my bad.

DoubtedNeon wrote:ya its 45, I just did this. and it sucked.

u fool. you told me it was a 20 degree bend yesterday when i asked ya. its ok tho.

Neon4Life wrote:

acr wrote:no its a 45 degree bend 2.25 inch pipe.

oo snap. ok. my bad.

DoubtedNeon wrote:ya its 45, I just did this. and it sucked.

u fool. you told me it was a 20 degree bend yesterday when i asked ya. its ok tho.

A good suck will put a little more curl in about anything.

If you are in need of the actuator motor pm me. I have a used one.

back on topic would be nice haha