Page 1 of 1
exhaust change
Posted: Thu Apr 29, 2010 8:16 pm
by blueneo03
did they change the exhaust from 03 to 05.. i got a stock muffler from the jy off of an 05 i believe and i went to put it on today and it didn't fit... it hung too low on the driver side.. and also when i pushed it up it hit the under body... so did they change anything on the exhaust between 03 and 05?
Posted: Thu Apr 29, 2010 8:54 pm
by nofrills05
TMK the rear muffler section was the same from '00 to '05, but I could be wrong.
My ex-gf's '03 rear stock muffler fit on my mom's '02. Though it's not he same years are you are referring to I don't see why they would change.
Posted: Thu Apr 29, 2010 10:25 pm
by blueneo03
that was my thought... i know the general setup was the same... but im not sure if it was maybe a little more pipe on the muffler side on the later ones than on that of the earlier years..
Posted: Fri Apr 30, 2010 11:36 am
by nofrills05
I measured my old factory mufflers pipe from the muffler to the clamp, and then measured the one on my Mom's '02 (which is actually an '03) and they were the same.
Posted: Fri Apr 30, 2010 12:43 pm
by fixitmattman
Muffler was probabbly beat to hell/ bent when they were handling the car at the yard.
Posted: Fri Apr 30, 2010 12:50 pm
by nofrills05
^ True
Posted: Fri Apr 30, 2010 1:49 pm
by OB
Would the ULEV mufflers be different maybe? I know they got a smaller exhaust. But then again, I thought those weren't made in 03-05. Hmm.
Posted: Fri Apr 30, 2010 1:55 pm
by blueneo03
the back of the car was fine and the piping on the muffler is fine... not bent or anything.... so im just not sure..
Posted: Fri Apr 30, 2010 2:00 pm
by occasional demons
OB wrote:Would the ULEV mufflers be different maybe? I know they got a smaller exhaust. But then again, I thought those weren't made in 03-05. Hmm.
I think the main difference was the dual cats and 2" piping throughout. AFAIK, all the SE/SXT mufflers/axle back were the same dimensions.
Posted: Fri Apr 30, 2010 2:18 pm
by OB
Post a few pics of it john. Maybe include some accurate measurements too. I have two OEM mufflers in my garage as we speak that I can refer to.
Posted: Sat May 01, 2010 12:06 am
by FAC3L3SS
I used to have my OE ULEV muffler too, but it was all the same. SRT rear bolted right up to it, etc...
Posted: Sat May 01, 2010 12:04 pm
by neonslg09
FAC3L3SS wrote:I used to have my OE ULEV muffler too, but it was all the same. SRT rear bolted right up to it, etc...
This. ULEV mufflers are no different than to any other OEM muffler. I had the ULEV system in my car, mufflers were the same blah blah blah.
Posted: Sat May 01, 2010 12:20 pm
by blueneo03
ill get some pics up on sunday or monday.. im out of town for a little bit but ya i guess a pic would show best what i mean..
Posted: Sun May 02, 2010 9:20 am
by Diamond
Yes they are the same.