What to do with this? Is this necessary?

00Neon RCR · Post by **00Neon RCR** » Tue Apr 12, 2011 4:24 pm

Hey. So as most people that are going to reply to this know I'm doing a 2.4 turbo swap. On my head (99 Cirrus) I have a valve of some sort (EGR I believe?). Can I eliminate this? The srt head I have doesn't have one so what can I do? Looks like there was sensor for it and it's not there anymore. I can provide pics too.

Thanks

Adam

Danteneon · Post by **Danteneon** » Tue Apr 12, 2011 5:12 pm

Without a picture, it sounds like you are talking about the EGR valve. Just block it off. You can get a MP EGR delete kit, or go the cheap route and cut a piece of 1/4" steel and bolt it on. Make sure you use an EGR gasket or high temp copper sealer on the mating surface.

00Neon RCR · Post by **00Neon RCR** » Tue Apr 12, 2011 5:56 pm

Thanks Dante. I actually just found that out from my buddy told me the same thing. He has one on his.