Page 1 of 1
Valvecover question
Posted: Tue Jul 19, 2011 8:37 pm
by unleashedcc
I just got a 1st gen aluminum valve cover with the pcv on the top. I ordered a new gasket set for it and i noticed that the bolts might be different since the rubber seals are different, true? Do I need 1st gen valvecover bolts or could I use my 2nd gen ones?
EDIT- also, does the 1st gen valve-cover require a pcv? could i just run it with an oil catch can?
Posted: Tue Jul 19, 2011 9:51 pm
by sneakers O'toole
i can't say for sure as i just used the bolts that were already in my 1gn cover... you'll need a 1gn pcv valve though.
Posted: Wed Jul 20, 2011 7:12 pm
by unleashedcc
for those that do a 1st gen valve cover swap, you will need 10 1st gen valve cover bolts (2gn will not fit) a pcv valve, and of coarse a 1st gen valve cover gasket set
took a trip to a junkyard for my bolts
Posted: Wed Jul 20, 2011 10:58 pm
by Mat00ES
I used my 2nd gen bolts and they worked fine
Posted: Fri May 11, 2012 6:56 pm
by NEON PARABOLA
BUMP
guys help me out here, I got the pcv valve but it's obviously two diffrent diameters on the inlet and outlet sides, what sizes of tubing do i need to get from valve cover, to pcv, from pcv, to intake manni?
Posted: Fri May 11, 2012 7:02 pm
by jckevns
viewtopic.php?t=9787
heres a how to, that should help yah out
Posted: Fri May 11, 2012 7:36 pm
by NEON PARABOLA
thanks!!!