How do u remove the IAT sensor?

Alex Kurdian · Post by **Alex Kurdian** » Tue Jul 26, 2011 6:10 pm

Hey Guys
Does anyone know how to remove the IAT from the air intake snorkle? Does it just pull out or what?

cgneon · Post by **cgneon** » Tue Jul 26, 2011 6:42 pm

edit: just went and checked mine, its been so long, i dont think it will just snap out, i think what i did was take a pair of snips and snip the 4 tabs accessed through the side of the snorkel so i could pull it free.

i could snag a picture but u probably dont need a pic to figure it out..

Alex Kurdian · Post by **Alex Kurdian** » Tue Jul 26, 2011 8:10 pm

ok easy it pops out but there is a shitty metal clip that I ruined trying to pry it off ...the IAT is now in ...But its lose...? It won't fall out no way cause u really have to force it in there will it be ok if its a bit lose?

cgneon · Post by **cgneon** » Tue Jul 26, 2011 8:17 pm

If u had to force it in there how is it loose? I doubt it will fall out, but what I did was put a small hose clamp around the little nipple it goes in on the snorkel for good measure.

Alex Kurdian · Post by **Alex Kurdian** » Tue Jul 26, 2011 8:20 pm

Ohh no way mate it will fall out..I'm just concerned that being a bit lose it may not give a clean reading hot air from the engine bay may sneak in???

cgneon · Post by **cgneon** » Tue Jul 26, 2011 8:23 pm

Na you will be fine. Don't worry about it.

theColonel · Post by **theColonel** » Tue Jul 26, 2011 9:45 pm

Alex Kurdian wrote:Ohh no way mate it will fall out..I'm just concerned that being a bit lose it may not give a clean reading hot air from the engine bay may sneak in???

use duct tape to seal it

2GN.ORG

How do u remove the IAT sensor?

How do u remove the IAT sensor?

ok

no

Re: no