R/T exhaust question

blackjack23 · Post by **blackjack23** » Mon Aug 01, 2011 1:02 pm

is there any way i can take most of the rust off and refinish it without the shiny chrome, and maybe put on high temp satin black enamel paint? is that possible? how hot does the exhaust system run anyways?

DetergentCandy · Post by **DetergentCandy** » Mon Aug 01, 2011 1:51 pm

Remove muffler.
Sandblast.
Spray with high temp satin black.
Reinstall.

Manifold enamel will be just fine

blackjack23 · Post by **blackjack23** » Mon Aug 01, 2011 3:19 pm

what about this paint?

http://www.homedepot.ca/product/high-he ... sol/980161

it's rated at 650*C(1200*F), is that enough?

DetergentCandy · Post by **DetergentCandy** » Mon Aug 01, 2011 4:53 pm

Yup

blackjack23 · Post by **blackjack23** » Mon Aug 01, 2011 4:58 pm

how many cans do you think i would need? and if i dont' have a sandblaster? :/

DetergentCandy · Post by **DetergentCandy** » Mon Aug 01, 2011 6:08 pm

http://www.autozone.com/autozone/access ... 643195_0_0_

Give that stuff a shot. There's many other products out there that do the same thing.
Sand it heavily, and then clean it with acetone.
Then you should be good to paint

blackjack23 · Post by **blackjack23** » Mon Aug 01, 2011 7:16 pm

hmm, im in canada and not sure where i could get that kind of product here xD