First Gen metal valve covers
Posted: Sun Aug 28, 2011 8:36 pm
like this one
it will fit any year SOHC head, correct?
Thanks
it will fit any year SOHC head, correct?
Thanks
2GN.ORG
The best source for the Second Generation Neon - Period.
https://forum.2gn.org/
First Gen metal valve covers
Page 1 of 1
Posted: Sun Aug 28, 2011 8:40 pm
yes, but you need the 1st gen pcv valve and i think you need the 1st gen gasket kit cuz its a bit diff then 2nd gen.. not 100% on that last part..
Posted: Sun Aug 28, 2011 8:53 pm
Correct, the gasket is different.
A 2gn PVC valve could be made to work, as I have mine plumbed like a 1gn/old school routing, but with the 2gn valve. For the 1gn VC, you would just need a 3/8 pipe to 3/8 barb adapter, some 3/8 vacuum hose, and clamps.
Something like this, except with a barb, instead of the compression as shown, unless you want to run metal/hard plastic tube to a catch can.
A 2gn PVC valve could be made to work, as I have mine plumbed like a 1gn/old school routing, but with the 2gn valve. For the 1gn VC, you would just need a 3/8 pipe to 3/8 barb adapter, some 3/8 vacuum hose, and clamps.
Something like this, except with a barb, instead of the compression as shown, unless you want to run metal/hard plastic tube to a catch can.
Posted: Tue Aug 30, 2011 12:57 am
You will definitely need the 1st gen gasket set. It comes with new grommets for the bolts.
PCV is up to you. I've been running the 1st gen setup for years now with zero oil in the intake.
PCV is up to you. I've been running the 1st gen setup for years now with zero oil in the intake.