2GN.ORG

Are there any differences between a udp for a 2.0 for neon, 2.4 l for pt gt and srt4 and 2.4l stratus and cirrus motors. I'm almost certain they can all use the same udp but I want make sure I don't buy a wrong one


My application applies to a stratus 99 motor so if it's specific that's what I'm looking for.


Thanks for any help guys.

The main difference is whether there is a V belt, or a poly V belt. The 1st gen style have one V groove in the pulley.

So will any 2.4 pt , pt gt, srt4, or stratus cirrus Udp work on a stratus 2.4, nevermind the 2.0 neon ones , I have looked at a few pulleys and I want to make sure I buy the right one.

IDK if the 2.4's used the V belt also, you just want to match the belt style more than anything else. The 2.0 and the 2.4 use the same part. It just depends on the belt set up.

My intention is to run my 2.0 alternator and 2.0 power steering, so will an SRT or pt gt udp work those, or are they different.

As long as the pullys are made for the flat belt, it will be fine. Most UDP's are sold as the 2.4 style for the wider belt. The narrower belt works just fine. (4 groove vs 5 groove)



viewtopic.php?t=6074

viewtopic.php?t=12651

Thanks. I ordered a SRT udp!