2GN.ORG

So here is my dilema, My muffler is so close to the bumper that it is near impossible to put a new muffler with exhaust tips. That and the muffler tip is in a slanted down angle. I want to put something like this:

Which would mean cutting the exhaust further back and making a straight pipe into the end of the muffler and then having it come out under the bumper with either a slight angled pipe or cutting into the bumper itself.
Or I could go with this:

Which cost a hell of alot more.

Would you all suggest the relocation with some new mounting points or the Magna flow. Also I dont belive the rear bumper on the car is the right one, I bought the car used so I know it has been in an accident at one point based on some tell tell signs, like paint and location of things etc.. Thanks for any help and suggestions.
X

the stock system tucks up pretty close and comes in a turndown yes... personally i dont really like the first type.... i think they look trashy

and i would just get the magnaflow on there if you got the money

or you can get an r/t dual exhaust or an srt dual exhaust

Trubendz makes a kit as well http://www.mandrelexhaustsystems.com/se ... Categories

Donkeypuncher wrote:Trubendz makes a kit as well http://www.mandrelexhaustsystems.com/se ... Categories

Those are not a bad Idea either. That kit might work a bit better as it is cheaper. Will look into it. Thanks for the tip.

Dual. I've never liked the first one.

A custom camaro setup is another option, a few of us have gone that route. It requires a little more work though.
viewtopic.php?t=30465