Float..
Posted: Wed May 30, 2012 7:18 pm
Hey guys....i have a problem I didnt know what place to put this...my gas gage is wierd...its always says yhere is more gas in it then there is...any one know how to fix this
You could loosen it enough to turn it, but prolly going to have to pull it up and reseat it to get the gasket loose enough to let it turn. You will want to be sure all the crud is cleaned first.
Then key on, note gauge position, and turn it until the gauge is at it's lowest position. For the love of god, don't short any wires out.
You could pull the FP relay, tho it should shut off after a second when keyed on. Better to be safe, then you only have the gauge wire that is energized.
Other than that, there is not much you can do, except replace the sender, and hope it reads closer to the tank level. Kind of a risky investment.