2GN.ORG

lol, trying to do what I can with what I have...should I reroute it?

As for the heater hardlines, damn that sounds like a PITA...but def will have to dedicate some time for that

Nah, its fine how it is. As long as its doing its job, the routing is all up to you

Yep, as long as it functions, it's more important than looks. Besides like I said, unless you get the pre molded hose it will be a pain to keep it from kinking. You don't need that on a booster hose.

For hardlines you can run just the rubber hose like Danteneon if the tubes did rust through.

Or go all out, and get creative.

is that PVC bill?

Hudson_Neon wrote:is that PVC bill?

I think its copper piping: http://www.homedepot.com/h_d1/N-5yc1vZb ... ogId=10053

Then painted...definitely looks like work but no way can I do that

Heater hard lines EJ.

Yep, copper tube. The sweat fittings, anyone could do with a hacksaw/tube cutter (preferred) solder, soldering paste (acid) and a propane torch.

Its those other bends I made you might not have much luck with, unless you have a 5/8" od pipe bender.

It could all be done with sweat fittings/straight tubing, but unless you can find some decent pricing besides HD or Lowe's it could get pricey. But still much cheaper than $235.00

That is for a 1gn DOHC, which I was having no luck finding used, and it is not available new. I couldn't move forward with my project neon, until I had fabbed it up, so I could bolt on the IM.


Edit: Oh yeah, the only place I could find that stocked 1/2 sweat x 3/8 NPT female was Lowe's.

For the rubber hose nipples I went with Dorman 56120 /AutoZone pn 500-001.1 $3.49 each about $3 cheaper each than Advance, $1 cheapr than Summit Racing.

Shit, come to my advance store... I'll price it at $3.49

That would be one hell of a drive.