Page 1 of 1

throttle position sensor

Posted: Sun Jul 28, 2013 1:25 pm
by mickeytopher
So i finally got the code for the TPS/IAC. I was looking at the TPS and the torx head on on of the scews is so rusted that i cant get a bit in there. What kind o thread di they use on those screws it looks very coarse almost like a wood screw[/b]

Posted: Sun Jul 28, 2013 8:01 pm
by occasional demons
Basically what is in there, but not quite the same as a wood screw. More like the screws that hold plastic drill cases together.

Some TPS's come with new screws, but IDK about the neon's, as I have never bought new for it. Not sure if the dealer even sells those screws separately.

Posted: Fri Aug 02, 2013 12:24 am
by kc2005ptgt
Try a junk yard, and just start removing screws from the engine/interior, and place in pocket.... :-**

Posted: Fri Aug 02, 2013 9:31 am
by 2k1MotorSport
kc2005ptgt wrote:Try a junk yard, and just start removing screws from the engine/interior, and place in pocket.... :-**
That's the best thing you can do..