Stock Neon compression rating for test?

This is the place to ask questions about your engine components like cams, valves, pistons… just anything that is generally "engine" specific. This also includes questions about exhaust systems such as exhaust manifolds, piping size, mufflers, ect...
Post Reply
Black_on_Black_Neon
2GN Member
Posts: 27
Joined: Fri Apr 18, 2014 2:47 pm

Stock Neon compression rating for test?

Post by Black_on_Black_Neon » Thu May 15, 2014 10:47 pm

Im going to compression test my 02 Neon r/t tomorrow. I would like to know what the wet/dry compression is supposed to be?

And when you do the test, you take out 1 plug at a time and crank it 3 times?

If you know what stock numbers are, what would you think I would be pushing w 138k miles?

As always thanks for the advice!

05MoparSRT4
2GN Member
Posts: 110
Joined: Tue Dec 10, 2013 6:21 pm

Post by 05MoparSRT4 » Thu May 15, 2014 10:52 pm

compression should be 170-225 (new motor of course) with 25% max variation
Image

r/tguy02
2GN Member
Posts: 3644
Joined: Sat Jul 07, 2007 11:42 pm
Location: carlisle, pa.

Post by r/tguy02 » Fri May 16, 2014 7:20 am

my stock engine was 120 across the board dry, wet i cant remember but it was pretty high
Justin
[02 R/T sold][00 Highline sold][04 r/t scrapped][95 NYG Sport coupe][01 r/t DD]
http://www.cardomain.com/ride/2931823

JeffB#2
2GN Member
Posts: 428
Joined: Sun Jun 03, 2007 6:55 pm

Post by JeffB#2 » Fri May 16, 2014 10:48 am

Just pull all of the plugs, not that it makes a big difference. Crank it over with the gas pedal to the floor and keep cranking until the gauge stops rising. You'll usually see it stop rising by the time it spins over 10 revolutions. Dry should be in the range noted above with stock pistons and stock cam. Wet will always be higher.
BoogerMan
'95 Ply NYG ACR sedan 12.31 @ 111 all motor 2.4 swap - puked
'95 Ply NYG Sport Coupe 2.4 SOHC. Yes, 2.4 single cam.
'01 ACR Stone White
www.boogerbushings.com

Image

occasional demons
Junior Admin
Posts: 19399
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Fri May 16, 2014 11:10 am

05MoparSRT4 wrote:compression should be 170-225 (new motor of course) with 25% max variation
With the minumum spec for used at 100 PSI.

It will run with less than 100, provided the variance is within 10%, but it will shake like a dog pooping razor blades with the A/C on (at idle). Or probably in gear with an ATX.
Bill
dblsg wrote:ya'll a bunch of post whores
epic

2001 Neon ES MTX with '02 R/T PCM
Help support 2GN!

Post Reply

Return to “Engine”