Crankshaft Main Bearing Set SET w/ Tabs on one side or both
Crankshaft Main Bearing Set SET w/ Tabs on one side or both
I am looking into rebuilding the bottom end of my 04 sxt 2.0 in the near future and when looking at rockauto master rebuild kits I noticed the "Crankshaft Main Bearing Set" has two options. Tab on one side or both. I'm not sure which one I would need. Is there a certain one I have to have, or is it optional? Is there a kit I should look into instead of the rockauto dnj kits? I plan on having block hot tanked and decked and bored if necessary and then do the rest of the work myself. So far I've replaced the whole top end with reman head and cam, timing components water pump etc, and all new mounts. Motor and tranny. Thanks for the help in advance!
- sidepipe87
- 2009 Silver Contributor
- Posts: 9516
- Joined: Fri May 30, 2008 5:35 pm
- Location: Pittsburgh, PA
- Contact:
If I remember correctly from the last 2.0 I did, they only had tabs on one side but I may be wrong. I used DNJ rings because they were cheap on that build. Personally, I'd go for the Clevites since they are a known brand. They're only $31 shipped on ebay. The DNJ may do just as well though.
http://www.ebay.com/itm/Engine-Cranksha ... f5&vxp=mtr
http://www.ebay.com/itm/Engine-Cranksha ... f5&vxp=mtr
PM me for your 00+ PCM SKIM/VIN flashing needs. Neon PCMs Plus