2GN.ORG

Posted: **Thu Feb 26, 2009 4:34 am**

I am going to replace my axles then I do my motor swap and suspension rebuild. The axles I was looking at are cheaper and available but only come in an "with ABS" version and my car does not. Does it make any difference? I know the ABS has the gear teeth on the shaft. Will they get in the way?

Posted: **Thu Feb 26, 2009 6:00 am**

They shouldn't get in the way, afaik they only used 1 knuckle/upright on all 2gn's (not including SRT)

Posted: **Thu Feb 26, 2009 2:56 pm**

You will be fine. The gear teeth do not get in the way at all. I'm running an ABS driver's side half shaft on my non-ABS car right now.

2GN.ORG

ABS vs non-ABS axle?

ABS vs non-ABS axle?