2GN.ORG

Posted: **Sat Nov 07, 2009 7:15 am**

Wondering if any 2g owners have done the 'Kyle Mod', replacing the bushing end of the shift cables with rod ends, i need to do it to a set of 2g cables for my 1g (needed the extra length) but i dont see how its possible. the driverside cable bottoms out against the flat portion where the adjuster goes, where as the 1g cable doesnt leaving room to thread the end.

if you dont know what i'm talking about here is some pictures of it done on a 1g.
http://forums.neons.org/viewtopic.php?p ... 9#p2443389

Posted: **Sat Nov 07, 2009 9:27 am**

Mopar00Neon wrote:Even if the plastic piece that holds the boogers broke, you dont need new cables.

I broke mine swapping my stock shifter for an SRT shifter. Do a search on the other .org for 'kyles rod end mod'... just cut the cable, thread it, and thread on the rod end. Its been working fine in my car for quite a few years now. I have Boogers on the tranny side, and rod ends in the interior.

SGT BRAD wrote:
yikes what about when you put the threaded solid shifter ends on like me!!! my shifter moves like robocop!!!

Ugh! I seen a post that had pics, different than the one you linked, but I can not find it.

Posted: **Fri Nov 20, 2009 6:18 am**

Check out my progress log, I did it to repair one of my cables

2GN.ORG

Anyone put rod ends on their shift cables? (aka Kyle mod)

Anyone put rod ends on their shift cables? (aka Kyle mod)