2GN.ORG

ok here is the down lo

i have a grinding sound on the right front side

replaced:
Bearing , drive shaft, new rotor and pads,

still hear grinding sound but when i turn right it goes away ,
i think the ball joint is going should i replace that and how about the motor mount upper and lower should i replace those or fill them

does any one have any suggestions

I was thinking axle or CV joint.

Don't know if the balljoints would cause that noise. At least i've never seen that as a sypmtom...but I could be wrong.

You sure the hub is good? Alot of times if the bearing went bad its best to also replace the hub. It can lead to the bearing not seating well or wearing out quicker.

It could be a stuck caliper.

lol after replacing the whole front end ei: berrings, drive shaft , balljoints and linkage kit and rotors and breaks pads

it was still grinding so i changed the last thing that was left to replace and it was the calipers i guess one was stuck so i replaced both now car drives nice but now lol all struts need to be replaced lol

thanks for all the help guys

Well look at the bright side, you have spare half shafts, unless you traded them for cores.

after all that it was both hubs and both struts in the front lol all fixed now