2GN.ORG

I'm getting ready to install the my new obx lsd and i'm wondering if that list on vitors webpage is only a guide to stuff i should actually replace with the new diff. any input is appreciated

new cone bearings and races.
new ring gear bolts

did you upgrade all the washers and bolts on the LSD yet? did you do all the needed machining to the splines?
if not follow this guide
viewtopic.php?t=54375

i bought the bolt and washer upgrade kit. i'm not gonna bother with machining the splines i'll just run it with out c clips. when you did yours did you replace all those parts listed?

actually damn his site is down but vitor had a pretty long list.

http://www.srtforums.com/forums/f75/how ... 3s-463874/

This is a good howto as well, but for the t-850 trans.

What I listed is all you need. However I would have a shop reshim and check the turning torque of the differential.

^^^^ This.
You don't want to eat up the ring gear/output shaft.

i'll be doing the turning torque myself, i'll be doing the clutch at the same time so this will be a fun filled weekend.

well i got the lsd installed and it is definitely gonna take some getting used to.

Care to elaborate? What size shims did you end up using?

the dealership said i could use the stock ones so i did, plus i didnt replace the races since the old ones were in great condition. getting used to both wheels driving is what i was referring to.

is there a site where i can get a rebuilt OBX diff?

I haven't seen any that sell them already rebuilt, only ones that offer the service.