SRT-4 Clutch in t350

Questions about axles, transmissions, differentials, pretty much anything that connects the engine to the wheels, this is the place for those questions.
Post Reply
2GN Member
Posts: 42
Joined: Tue Jul 24, 2012 3:49 pm

SRT-4 Clutch in t350

Post by 847SRT4 » Thu Dec 06, 2012 9:28 pm

I know it wont fit, but what exactly gets shaved down when people put them into t350's? Also who still does this?

2GN Member
Posts: 439
Joined: Sat Mar 05, 2011 11:00 am
Location: Mechanicsburg PA

Post by boostalot717 » Thu Dec 06, 2012 9:33 pm

The O.D of the pressure plate. Not sure who does this. But why not just use a aftermarket clutch?

occasional demons
Junior Admin
Posts: 19731
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Thu Dec 06, 2012 10:44 pm

It is both the flywheel, and the pressure plate.

JeffB#2 wrote:You can't just reduce the diameter. You also have to cut the back side to make room for the flex plate. If you use that as-is- you will bend the living crap out of the flex plate when you tighten down the four bolts to the clutch. You MUST cut down the flywheel until you are within a couple of thousands above the rivet heads. The ring gear is welded to the clutch side of the flexplate.

blue demon02 wrote:Image

dblsg wrote:ya'll a bunch of post whores
Seriously people, this is 2019 not 1920.
Too much time spent here is a sign of a bad case of Ownaneonvirus.

2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Help support 2GN!

Post Reply

Return to “Drivetrain”