Page 1 of 1
aftermarket wastegate for the srt setup
Posted: Wed Jul 26, 2006 6:27 pm
by tooslow
ok I am running about 8psi but around 7k rpm it bleeds down too about five I want a waste gate that does not up the boost but won't bleed down that much. What are my options and what would you recomend
thx
Posted: Wed Jul 26, 2006 6:36 pm
by Kevin_GP
I think you just need a better boost controller. I think most aftermarket waste gates dont even open untill 15+ psi. What boost controller do you have now?
Posted: Wed Jul 26, 2006 6:43 pm
by tooslow
turbo xs the high performance one. I bought it used not sure if it might be as good as it used too be do boost controllers go bad?
Posted: Sat Jul 29, 2006 12:55 pm
by 60trim
are you sure you have the controller hooked up right? from what I understand, the design was backwards and the flow direction was opposite from what the company says. Try switching your lines around, build into boost carefully and see how it reacts
Posted: Sat Jul 29, 2006 1:03 pm
by tooslow
yeah I will try that I'll just set over boost protection around 9 psi too be safe
Posted: Sat Jul 29, 2006 1:04 pm
by 60trim
set the wastegate to 0 if possible and run straight boost controller, that would be the best bet, considering the wastegate could be malfunctioning in some odd way.
Posted: Sat Jul 29, 2006 1:17 pm
by tooslow
I gonna change out the blow valve. It might be leaking out boost well see I about too go tear into it so we will see
Posted: Sat Jul 29, 2006 1:18 pm
by 60trim
what BOV? I have the SARD R2D2, loud as hell, up there with the RFL. The HKS SSQ doesn't leak due to the self adjusting valve.
Posted: Sat Jul 29, 2006 1:21 pm
by tooslow
it is just the forge derict replacement blow of valve
update
it was the blow of valve it holds boost fine now