Wastegate question on stock srt-4 manifold

LionheartedSXT · Post by **LionheartedSXT** » Sat Jun 21, 2008 12:42 pm

So I have an srt-4 mani for a turbo build and it came with the mani, turbo, wastegate, and surge valve...and i noticed that the arm of wastegate actuator comes off pretty easily off the switch of the wastegate, is there supposed to be like a holding pin present in there to hold the arm down on the switch?

Wenuden · Post by **Wenuden** » Sat Jun 21, 2008 4:30 pm

yes. its a clip, not a pin tho. Just get a cotter pin and bend it back after you put it thru.

LionheartedSXT · Post by **LionheartedSXT** » Sat Jun 21, 2008 9:49 pm

I already did something about it but I just wanted someone's opinion on it. I took a piece of metal from one of those things you hold corn with and bent that around it. cheap, but effective lol

Swordfish2Cowboy · Post by **Swordfish2Cowboy** » Sun Jun 22, 2008 1:28 am

Does it have the corn cob on the end, too?

LionheartedSXT · Post by **LionheartedSXT** » Sun Jun 22, 2008 3:35 am

lol sure does haha

blue demon02 · Post by **blue demon02** » Sun Jun 22, 2008 2:22 pm

LionheartedSXT wrote:I already did something about it but I just wanted someone's opinion on it. I took a piece of metal from one of those things you hold corn with and bent that around it. cheap, but effective lol

I have used a safety pin before but thats just awesome!

LionheartedSXT · Post by **LionheartedSXT** » Sun Jun 22, 2008 2:50 pm

blue demon02 wrote:
LionheartedSXT wrote:I already did something about it but I just wanted someone's opinion on it. I took a piece of metal from one of those things you hold corn with and bent that around it. cheap, but effective lol
I have used a safety pin before but thats just awesome!

lol thanks man

, it was the first metal thing that I found in the kitchen haha