does anyone kno the bends of the I/C piping

phs17 · Post by **phs17** » Mon Mar 09, 2009 3:14 pm

trying to figure out the bends thanks

Adionik · Post by **Adionik** » Mon Mar 09, 2009 3:31 pm

Your best bet is to get the stock SRT IC piping and modify them from there. I don't know how good the charge pipe will fit...I know you're definitely going to cut holes though

phs17 · Post by **phs17** » Mon Mar 09, 2009 3:43 pm

i bought a charge pipe that was already cut for the 2.0 . but i dont think i have a way to bend the pipes . are the pipes on ebay already bent by anychance ?

hul kogan · Post by **hul kogan** » Tue Mar 10, 2009 11:42 am

You can buy piping kits on eBay that will give you a variety of bends and straights. The piping required can then be fabbed up from there. It will be a lot easier if you have access to something you can cut the pipe with and have the ability to tack them before taking them to a welder.

n20sxt · Post by **n20sxt** » Tue Mar 10, 2009 12:52 pm

phs17 wrote:i bought a charge pipe that was already cut for the 2.0 . but i dont think i have a way to bend the pipes . are the pipes on ebay already bent by anychance ?

the universal kits are mad cheap and also come with a fairly nice intercooler, and nice couplings .. go with the ebay kit for like 200 bucks and then just cut it to fit your car

phs17 · Post by **phs17** » Tue Mar 10, 2009 12:56 pm

yea i think thats what im going to do thanks guys

yellowpatrol · Post by **yellowpatrol** » Tue Mar 10, 2009 3:31 pm

Does this help you?